Gluing Chines

I did spend some time figuring out how to glue the chines logs in place. At about 14 foot long, they are quite unwieldly, and epoxy is slipperier that a slippy thing in slippy sauce. It's all very well saying the screws will hold it in place, but as you try to position the end at the transom, or perhaps at the stem, and the other you suddenly find this wisdom somewhat incomplete, as your epoxy starts to set.

One simple solution is to screw it in place staring at the middle without glue. Then mix up the epoxy suitably stiffened with amorphous silica. Only then do you unscrew the aft half of the chine, whack on the glue, then screw it back in place. The other end is suitable tamed. Then unscrew the forward half, apply the glue and replace it. Simple. It's like having a strong patient helper at the other end.

I got truly sick of stripping the head off the (expensive) bronze screws, so now
I use square head deck screws dipped in molten bees wax to hold things together. Much stronger than Bronze. And square heads just don't strip out. When it's suitably set (which may be several days, it's cold out there) I will replace the galvanised deck screws with Bronze.

I am assuming that there will not be so much epoxy in the existing screw hole that it prevents me inserting the bronze ones. Wish me luck.